8900
1 "medidor NPT para tanques domésticos, cilindros DOT y combustible de motor
Application
Gauging LP Gas levels in ASME tanks and DOT Cylinders.
General Information & Features
This series of 1″ NPTF Junior gauges is available with forged brass head.
Now with R3D®
The Rochester Remote Ready Dial, R3D®, is a magnetically-driven, Hall Effect compatible dial. Dials are utilized on stationary applications where direct reading plus an electrical signal to a remote fuel level monitor may be required.
El módulo de efecto Hall de Rochester está diseñado para encajar en el hueco en el objetivo de dial Ready remoto. Una vez instalado, el módulo puede proporcionar una salida de tensión ratimétrica proporcional al volumen de líquido dentro del tanque.
Documents
B8900 Series Data Sheet
8900 Series Gauge Installation Instructions DS-629
MS-516 Installation Instructions
Modelo | Head material | Montaje | Tipo de marcado |
---|---|---|---|
B8981 | Latón | Arriba | R3D® lectura directa, atornillado |
B8981-02000 | R3D® de lectura directa, Snap-on |
Especificaciones generales *
Temperature
Extremes are -40°F to 158°F, -40°C to 70°C.
Working Pressure
375 psig [25,8 Bar]
Accuracy
Accuracy depends upon proper gauge sizing and is typically ±5% of R3D® dial indication. Accuracy may be less due to variations in liquid temperature. Accuracy may be less for some tank shapes and sizes. Accuracy may be less if tank is not level. Accuracy may be less near empty and full. This gauge is not to be used for filling. R3D® dial output voltage is typically ±4% of indicated reading. All accuracy estimates are percent of full scale.
Approvals
Gauge is UL listed for LP Gas service applications.
R3D® Module is UL Classified as intrinsically safe.
Al ordenar especifique:
1. Specify tank diameter (shown on tank nameplate).
2. Specify the gauge mounting location.
3. State they type of cylinder, horizontal or vertical.
4. Specify the “H” dimension. This is the distance in inches from the surface of the tank to the top of the threaded opening.
Para ordenar el medidor de reemplazo, simplemente proporcione la información estampada en los pisos desgarradores hexagonales como se muestra en el ejemplo.
Materiales de construcción *
Head
Brass forging.
Centershaft Bearings, Pinion Gear, Cross Stud & Bearing, & Sector Gear
Stainless steel.
Gear Housing
Acetal.
Support, Centershaft & Float Rod
Tempered aluminum.
Float
Nitrile rubber.
Counterweight
Lead.
Magnet
Neo.
Direct-reading Dials
Hermetically sealed polycarbonate.
R3D® Direct-reading Dial
Hermetically sealed polycarbonate.
* Los materiales y especificaciones están sujetos a cambios sin previo aviso. Las clasificaciones de presión están sujetas a cambios debido a la temperatura y otras consideraciones medioambientales.