Consent Preferences
WarningFlammable

8900

1” NPT Gauge for Domestic Tanks, DOT Cylinders and Motor Fuel

Application
Gauging LP Gas levels in ASME tanks and DOT Cylinders.

General Information & Features
This series of 1″ NPTF Junior gauges is available with forged brass head.

Now with R3D®
The Rochester Remote Ready Dial, R3D®, is a magnetically-driven, Hall Effect compatible dial. Dials are utilized on stationary applications where direct reading plus an electrical signal to a remote fuel level monitor may be required.

Rochester’s Hall Effect Module is designed to snap-fit into the recess in the Remote Ready Dial lens. Once installed, the module can provide ratiometric voltage output proportional to the liquid volume inside the tank.

Documents
B8900 Series Data Sheet
8900 Series Gauge Installation Instructions DS-629
MS-516 Installation Instructions

Model Head Material Mounting Dial Type
B8981 Brass Top R3D® Direct Read, Screw-on
B8981-02000 R3D® Direct Read, Snap-on

General Specifications*

Temperature
Extremes are -40°F to 158°F, -40°C to 70°C.

Working Pressure
375 psig [25,8 Bar]

Accuracy
Accuracy depends upon proper gauge sizing and is typically ±5% of R3D® dial indication. Accuracy may be less due to variations in liquid temperature. Accuracy may be less for some tank shapes and sizes. Accuracy may be less if tank is not level. Accuracy may be less near empty and full. This gauge is not to be used for filling. R3D® dial output voltage is typically ±4% of indicated reading. All accuracy estimates are percent of full scale.

Approvals
Gauge is UL listed for LP Gas service applications.
R3D® Module is UL Classified as intrinsically safe.

When Ordering Specify:

1. Specify tank diameter (shown on tank nameplate).
2. Specify the gauge mounting location.
3. State they type of cylinder, horizontal or vertical.
4. Specify the “H” dimension. This is the distance in inches from the surface of the tank to the top of the threaded opening.

To order replacement gauge, simply furnish the information stamped on the hex wrenching flats as shown on example.

Materials of Construction*

Head
Brass forging.

Centershaft Bearings, Pinion Gear, Cross Stud & Bearing, & Sector Gear
Stainless steel.

Gear Housing
Acetal.

Support, Centershaft & Float Rod
Tempered aluminum.

Float
Nitrile rubber.

Counterweight
Lead.

Magnet
Neo.

Direct-reading Dials
Hermetically sealed polycarbonate.

R3D® Direct-reading Dial
Hermetically sealed polycarbonate.

*Materials and specifications are subject to change without notice. Pressure ratings subject to change due to temperature and other environmental considerations.

Product Inquiry - 8900

    Related Products

    Revised 09-21-2015