F7183
1-1/4” or 1-1/2” MNPT Lever Gauge for Stationary Horizontal Cylindrical Farm Tanks or Tanks With Flat Heads
Application
These lever-action gauges are designed primarily for use in stationary horizontal cylindrical farm tanks or other tanks with flat heads. They are to be mounted on the centerline in the middle of the head. The maximum recommended float length is 48″ [1219mm]. They are available in either 1-1⁄4″ MNPT or 1-1⁄2″ MNPT versions.
General Information & Features
The float and rod assembly is normally shipped unassembled to the head assembly for maximum flexibility to your inventory. The float rod is cut to the proper length for each size tank, notched, then inserted into the sleeve attached to the short section of lever rod, and crimped for firm retention.
The standard # 5001s00605 fractional dial is used in stationary tanks. If the gauge is to be used in a mobile tank, a # 5002s00605 dampened fractional dial should be used. Other dials, calibrated in gallons or percentage, can be supplied on special order at extra cost. Field replacement of dials can be done without draining the tank by simply removing the dial screws, aligning a new dial and re-installing the screws, if needed.
Documents
Data Sheet
MS-516 Installation Instructions
115-1224 Float Arm Attachment Instructions
General Specifications*
Mounting
Designed for mounting on flat ends of horizontal, cylindrical farm tanks.
Accuracy
Accuracy depends upon proper gauge sizing and is typically ±5% of dial indication. Accuracy may be less for some tank shapes and sizes. Accuracy may be less near full and empty. Accuracy may be less if tank is not level. This gauge is not to be used for filling. All accuracy estimates are expressed as a percent of full scale.
Temperature
Standard operating range is -40°F to 158°F, -40°C to 70°C.
Humidity
Exposed portion suitable for outdoor applications.
Shock
Suitable for mobile applications.
Vibration
Suitable for mobile applications.
Tank Pressure
0 to 10 PSIG [0 to 0,68 Bar].
Approvals
U.L. listed for flammable liquids.
Materials of Construction*
Head
Aluminum die-casting.
Support Tube & Float Rod
Aluminum.
Drive Magnet
Alnico.
Bearings
Stainless steel.
Float
Nitrile rubber.
Dial
Aluminum with acrylic crystal.
When Ordering Specify:
1. Gauge model number.
2. Tank height.
3. Stationary or mobile application.
4. Any special requirements*.
*Materials and specifications are subject to change without notice. Pressure ratings subject to change due to temperature and other environmental considerations.
Product Inquiry - F7183/F7283
Related Products
WARNING: Acrylonitrile, BPA - Cancer and Reproductive Harm - www.P65Warnings.ca.gov
